Category Collection, Plumbing & Controls

IBC totes often have a 2-inch nominal outlet, commonly S60x6, but threads vary. Measure diameter and pitch and identify the standard before buying fittings.

A 2-inch overflow suits many rain barrels, but full downspout inflow may need more capacity. Size it for roof area, rainfall, fittings, and discharge route.

A bulkhead hole must match the fitting body's cutout, not its nominal pipe size. Measure carefully, use the maker's template, and keep the surface smooth.

Install a float valve where shutoff leaves freeboard below the overflow. Provide clear float movement, supported supply plumbing, access, and debris protection.

The bulkhead gasket usually sits between the fixed flange and tank wall on the wet side. Follow the fitting design, clean surfaces, and avoid twisting the seal.

The best hose connectors match thread and diameter, resist water and weather, seal with available gaskets, support pressure, and disconnect as often as needed.

Place an underground tank in stable soil with setbacks, drainage, load protection, service access, and practical connections. Follow engineering and local rules.

Place a sediment filter before equipment particles could damage. Its position relative to pumps and treatment depends on flow, pressure, and filter rating.

Plastic tanks are lighter to install; concrete suits large permanent storage. Compare site, cost, water chemistry, access, temperature, and lifespan.

The best screen mesh balances debris exclusion with storm flow and cleaning. Choose aperture, wire, material, area, and access for the inlet, vent, or overflow.